Fret Press Module - DIY Press Application


Screw operated modular fret press unit with fret caul for building into a DIY press

A potential pitfall in guitar workshops is repurposing a standard drill press to install frets. This can compromise the equipment, causing issues such as table deflection or quill damage, while also introducing safety hazards that should be identified through a basic risk assessment.

Fret press module

Our modular screw press mechanism is a versatile alternative solution, adaptable for both simple setups and larger guitar presses.

The Fret Press Module combines all essential fretting functions in one compact unit.


“One of the best tools I've ever bought. I will never hammer frets again!” STEVE S., Staffordshire UK


Technical Description


High force from a small unit

The screw is fitted with a thrust collar that connects to the fret caul, converting rotational torque into substantial pressing force.

A torque-arm handle ensures smooth operation.

Built on our engineering expertise and commitment to thorough risk analysis, our fret cauls are designed exclusively for use with the press module. They are not compatible with drill-mounted systems.

 

Simple workshop installation

The press can be easily mounted onto the underside of a beam. The maximum thickness for a simple beam is 40mm. If using a thicker beam, rebating for the press unit would be required.

A suitable solution is to utilise hardwood or CLS timber as per illustration.

Drill a 9mm hole through the centre of the beam for the press screw clearance.

Place the module upside down, locating the press screw thread into the pre-drilled clearance hole, to centralise the mounting plate on the beam.

Drill two 4mm pilot holes into the  support beam.

Tighten down the mounting plate with the supplied fasteners. 

Wind the screw thread through the beam until it protrudes at the top.

Fit the locknut and handle.

Tighten with a 13mm A/F spanner.

Fitting & removing cauls

The caul is located onto the press screw using a spring retained thrust collar.

To remove the fret caul - pull the thrust collar downwards.

To fit the caul - push collar up until it engages on the end of the screw.

Cauls (75mm Wide)

Stainless steel cauls can be purchased individually for tailoring the selection to your requirements.

Choose from 10 radius profiles: -

7.25", 9.5", 10", 12", 14", 15", 16", 17", 20", and Flat.