Fret Removal System
An Alternative Fret Puller To Pliers
Our dedicated fret puller offers an alternative when traditional end pliers are difficult to use.
Working from the side, specially profiled blades loosen the fret end away, allowing you to lever the fret upward. The tool slides over the included fret guard avoiding indentation of the fretboard.
“Just received the fret puller. Totally blown away. This thing is awesome. Every repairman or luthier should have one of these. Thank you”. C.W., Idaho, USA.
Wrap a small length of tape around the edge of the fretboard either side of the fret being removed. (The fret guard is not used at this stage).
Place the fret puller in position and locate the fret end.
Make sure the tips grip beneath the fret. As a reference, a depth of 1mm is suggested, although this may vary based on the wood's hardness and the condition of the fret end.
By using leverage through the tool to apply pressure on the fret guard, the fret end can be eased from the edge of the fretboard.
Place the fret guard in position and re-locate the tool tips underneath the raised fret end.
As the fret begins to lift away, the tool is drawn back along the fret using a rocking action.
Soft frets will curl and be enclosed within the tool.
Hard frets will remain straighter as they are levered out. When removing hard frets, apply finger pressure to the fret guard either side as shown above.
NOTE:
Some wood splitting when removing frets is inevitable, and minor cosmetic repairs to the fretboard will be needed. Work from the lower edge of the neck to ensure that repairs remain discreet.
The tool tips are manufactured from ground Sheffield Knife Steel. The tips are symmetrical with two working edges that can be dressed with a diamond file.